Results for: "DHCP"
...found 9 topics (0.199 secs)
1. From the topic:
network_basics
Basics Networking
If you are uncertain as to the proper settings for your network you may
try the Dynamic Host Conbfiguration Protocol (DHCP). Most routers enable
this protocol. This helps computers join the network and properly configure.
The JNIOR now ships with
DHCP enabled.
2. From the topic:
/IpConfig/DHCP
IpConfig/DHCP Registry Key
Hint: If you plan to set a fixed IP address and your network supports DHCP,
you can enable
DHCP briefly to configure your JNIOR properly for the network.
Subsequently you can disable
DHCP and apply the fixed IP address as might be
appropriate. All of the other parameters will then be properly set.
3. From the topic:
ipconfig
IPCONFIG User Commands
-R
Release
DHCP leased IP address and disable
DHCP.
4. From the topic:
network_access
User Interface Getting Started
In order to fully interact with the JNIOR and use its WebUI you must properly
configure the unit to operate on the network. JNIORs are now being shipped
from the factory with Dynamic Host Configuration Protocol (DHCP) enabled. With
a network supporting
DHCP the JNIOR will obtain a valid IP address and
automatically configure itself properly for the network. You will still
need to determine the IP address that it has been assigned.
5. From the topic:
/IpConfig/IPAddress
IpConfig/IPAddress Registry Key
10.0.0.201 (if
DHCP not enabled)