JANOS Help System: [Commands] [Topics] [Tech Support] [Printable Manual] [Search]
Usage Registry Key NAME IO/Outputs/[ROUT]/UsageState DEFAULT 1 (CLOSED) DESCRIPTION This specifies whether usage time is accumulated when the relay is in the CLOSED state (1) or in the OPEN state (0). The key is set to 1 or 0 respectively. Note that certain relays may be reconfigured from Normally Open (NO) to Normally Closed (NC) by jumper. This may affect the choice of metering state. ALARM ENABLE IO/Outputs/[ROUT]/Usage/Alarm DEFAULT disabled DESCRIPTION Set to enable an alarm when the associated usage meter reaches the Limit specified. USAGE LIMIT IO/Outputs/[ROUT]/Usage/Limit DEFAULT 0.0 DESCRIPTION Defines the alarm setpoint in hours and may include a fractional part. The associated relay output goes into alarm when the usage meter reaches or exceeds this setpoint. EVENTS ENABLE IO/Outputs/[ROUT]/Usage/OnAlarm DEFAULT disabled DESCRIPTION This key may be optionally defined to enable services related to Relay Output Usage Alarms. EMAIL ENABLE IO/Outputs/[ROUT]/Usage/Email DEFAULT disabled DESCRIPTION This Registry key enables Usage Notification email. CUSTOM EMAIL NOTIFICATION IO/Outputs/[ROUT]/Usage/EmailBlock DEFAULT None DESCRIPTION This may be used define a block that creates a unique Usage Notification message. HOLDOFF IO/Outputs/[ROUT]/Usage/HoldOff DEFAULT 300000 (milliseconds) DESCRIPTION This defines the amount of time in milliseconds that the Relay Output usage alarm must remain clear before any subsequent usage alarm on this input will be acted upon. The default is 300000 or 5 minutes. When an alarm occurs the services associated with that event are performed. The alarm must reset and remain so for this amount of time before those actions would be performed again. SEE ALSO HELP Topics: EMAIL_BLOCK [/flash/manpages/registry.hlp:3410]